Filter
Top Products
38
Playing (Play mode)
Normally, the velocity value of the transmitted notes will vary depending on how strongly you play the keyboard.
If desired, you can also specify a fixed velocity at which all notes will be transmitted regardless of how strongly you play the keyboard.
This is convenient when you want to record into your DAW software at a fixed velocity.
You can also adjust the sensitivity or velocity curve as desired.
If you want to use a fixed velocity, you’ll need to set the “VALUE ENCODER” system
setting for [USER] to “Key Velocity.”
* For details on how to make this setting, refer to the bottom of this page or to
VALUE knob settings
(p. 80).
If “KEY VELOCITY” is assigned to the VALUE encoder, you can use the following
procedure to transmit bank select (MSB, LSB) messages.
fig.H-User.eps
1
Press the [USER] button.
The [USER] button will light. The display will
indicate the most recently transmitted velocity
value.
2
Use the VALUE knob to specify the velocity
value (tch, 1–127) that you want to transmit.
fig.D-tch.eps
* If the display indicates “tch,” the transmitted velocity will depend on how
strongly you play the keyboard.
Refer to the system setting
Keyboard Velocity Curve
(p. 72).
Employing performance dynamics (Velocity)
Specifying a fixed velocity (Key Velocity)
Changing the keyboard touch (Velocity Curve)
Assigning the VALUE knob
Here’s how to change the VALUE knob’s [USER] button assignment to “Key Velocity.”
1. Press the [EDIT] button so it’s lit.
The display will indicate “EDIT.”
2. Press the [USER] button. It will light, and the display will indicate the
currently assigned parameter.
3. Use the VALUE knob to select “VEL,” and press the [ENTER]
button.
This completes the setting; you will return to Play mode.
PCR-300_500_800_e.book 38 ページ ２００６年１２月１９日 火曜日 午後２時５９分