Filter
Top Products
61
Settings (Edit mode)
Examples of system exclusive message assignments
•
GM2 System On
(p. 61)
•
Master Volume
(p. 62)
•
Bend Pitch Control
(p. 63)
Here are some specific examples of system exclusive messages.
GM2 System On
“F0 7E 7F 09 03 F7”
Let’s use basic editing mode to enter a GM2 System On system exclusive message.
1
Press the [EDIT] button so it’s lit.
The display will indicate “EDIT.”
2
Slightly move the controller to which you want to assign the system exclusive
message. If the controller is a button, press it.
The display will indicate the number of the controller you selected.
3
Check the indication in the display, then press the [ENTER] button.
4
Turn the VALUE knob to make “SE” appear.
5
Press the [ENTER] button.
6
Turn the VALUE knob to make “SE0” appear.
7
Check the indication in the display, then press the [ENTER] button.
The display will show the first byte “F0” (beginning status) of the system exclusive
message. (This cannot be changed.)
8
Check the indication in the display, then press the [ENTER] button.
9
Use controllers [A8 (7)] and [B7 (E)] to enter the second byte “7E.”
You can also use the VALUE knob to change the value.
10
Check the indication in the display, then press the [ENTER] button.
11
Use controllers [A8 (7)] and [B8 (F)] to enter the third byte “7F.”
You can also use the VALUE knob to change the value.
12
Check the indication in the display, then press the [ENTER] button.
In the same way, enter the fourth byte “09” and fifth byte “03.”
13
Finally, use controllers [B8 (F)] and [A8 (7)] to enter the ending status “F7.”
You can also use the VALUE knob to change the value.
14
Check the indication in the display, then press the [ENTER] button.
15
Specify the output port. (->
Port setting
(p. 65))
16
As appropriate for the type of controller, set the button mode (p. 64) or the virtual
center click setting (p. 65).
This completes the steps necessary to assign the GM2 System On message.
PCR-300_500_800_e.book 61 ページ ２００６年１２月１９日 火曜日 午後２時５９分