Filter
Top Products
43
Settings (Edit mode)
* If you assign a note message to [S1]–[S9], [R1]–[R9], or [P2], moving the controller to the maximum position will transmit a note message with the specified velocity value. Slightly lowering the controller from
the maximum position will transmit a note message with a velocity of 0.
* If you assign a note message to [A1]–[A9], [B1]–[B9], [C1]–[C3], [L1]–[L4], or [P1], turning the controller on will transmit a note message with the specified velocity value.
Turning the controller off will transmit a note message with a velocity value of 0.
Advanced editing 1
In Note Assign advanced editing 1, you can also specify the velocity value in
addition to the items in basic editing.
1. Press the [EDIT] button so it’s lit.
2. Slightly move the controller to which you want to assign a note
message.
If the controller is a button, press it.
The display will indicate the number of the selected controller.
3. Check the indication in the display, then press the [ENTER] button.
4. Make the display indicate “NT” (Note assign).
5. Press the [ENTER] button.
6. Turn the VALUE knob or press controller [A2 (1)] to make the display
indicate “NT1.”
7. Press the [ENTER] button.
The display will indicate “CH- -.”
* The - - portion shows the currently specified value.
8. Enter the MIDI transmit channel.
9. Press the [ENTER] button.
The display will indicate “N- -.”
* The - - portion shows the currently specified value.
10. Enter the note number.
11. Press the [ENTER] button.
The display will indicate “V- - -.”
* The - - - portion shows the currently specified value.
12. Enter the velocity value.
If the controller is [A1]–[A9] or [B1]–[B9], selecting “tch” will transmit a
velocity value that corresponds to the force with which you pressed the
pad.
13. Press the [ENTER] button.
The display will indicate “P- -” (MIDI output port).
* The - - portion shows the currently specified value.
14. Specify the MIDI output port.
(-> Port setting (p. 65))
15. If the controller is [A1]–[A9], [B1]–[B9], [C1]–[C3], [L1]–[L4], or [P1],
specify the button mode (p. 64).
16. If the controller is [A1]–[A9] or [B1]–[B9], specify the aftertouch
setting.
AFTERTOUCH OFF
Aftertouch output will be dis-
abled.
CHANNEL
PRESSURE
Channel pressure messages
will be transmitted.
POLYPHONIC KEY
PRESSURE
Polyphonic key pressure mes-
sages will be transmitted.
PCR-300_500_800_e.book 43 ページ ２００６年１２月１９日 火曜日 午後２時５９分