Filter
Top Products
57
Settings (Edit mode)
Using advanced editing 2
fig.D-F.eps
The display will indicate “F-.”
* The – portion shows the currently specified value.
8
Use the VALUE knob or controllers [A7 (6)], [B1 (8)], [B3 (A)]–[B5
(C)], and [B8 (F)] to specify the system exclusive message.
9
Press the [ENTER] button.
10
Specify the output port.
(->
Port setting
(p. 65))
Using advanced editing 3 or 4
fig.D-LSBSelect.eps
The display will indicate “L- - -.”
* The - - - portion shows the currently specified value.
8
Use controllers [A1]–[A8] and [B1]–[B2] to enter the number of
bytes you’ll be entering, as a decimal number.
9
Press the [ENTER] button.
10
Use controllers [A1]–[A8] and [B1]–[B8] to enter the first byte.
11
Press the [ENTER] button.
12
Enter the second and subsequent bytes in the same way.
13
When you’ve entered the number of bytes you specified in step 8, the message
you entered will be checked to see whether it is a valid MIDI message. If there is
a problem, the display will indicate “ERR.”
Press the [ENTER] button and you’ll return to step 8. Enter the values once again.
14
If you’re using advanced editing 4, specify the upper and lower value limits.
(->
Specifying the value range (upper/lower limits)
(p. 45))
15
Specify the output port. (->
Port setting
(p. 65))
16
As appropriate for the type of controller, set the button mode (p. 64) or the virtual
center click setting (p. 65).
PCR-300_500_800_e.book 57 ページ ２００６年１２月１９日 火曜日 午後２時５９分