Filter
Top Products
53
Settings (Edit mode)
You can assign an RPN or NRPN to a controller.
Basic editing (->
Advanced editing 1
(p. 54))
fig.H-Edit.eps
1
Press the [EDIT] button so it’s lit.
fig.D-Edit.eps
The display will indicate “EDIT.”
fig.D-r1.eps
2
Slightly move the controller to which you want to assign an RPN or
NRPN message.
If the controller is a button, press it.
The display will indicate the number of the controller you selected.
3
Check the indication in the display, then press the [ENTER] button.
fig.D-RPN.eps
4
Turn the VALUE knob to make “RP” appear.
* If you want to assign an NRPN, make “NP” appear. The rest of the
procedure is the same as for RPN.
5
Press the [ENTER] button.
fig.D-RPNEdit0.eps
6
Turn the VALUE knob or press controller [A1 (0)] to select the basic
editing “RP0” indication.
fig.D-ChannelSelect.eps
7
Press the [ENTER] button.
“CH- -” will be blinking in the display.
* The - - portion shows the currently specified value.
8
Enter the channel. Use the VALUE knob or controllers [A1 (0)]–[B2 (9)] to specify
the desired channel.
9
Press the [ENTER] button.
fig.D-MSBSelect.eps
10
Use the VALUE knob or controllers [A1 (0)]–[B2 (9)] to specify the
desired RPN MSB (CC#101) or NRPN MSB (CC#99).
* The - - portion shows the currently specified value.
11
Press the [ENTER] button.
fig.D-LSBSelect.eps
12
Use the VALUE knob or controllers [A1 (0)]–[B2 (9)] to specify the
desired RPN LSB (CC#100) or NRPN LSB (CC#98).
* The - - portion shows the currently specified value.
13
Press the [ENTER] button.
14
As appropriate for the type of controller, set the button mode (p. 64) or make
virtual center click settings (p. 65).
RPN/NRPN assign
Edit
Controller Display
Range of data entry MSB
(CC#6)
Range of data entry LSB
(CC#38)
Port
Basic editing
[A1 (0)] 0–127 (00–7FH) Not transmitted PORT 1
Advanced editing [A2 (1)]
You can specify the upper
and lower limits
0–127 (00–7FH)
PORT 1,
PORT 2,
PORT 1+2
PCR-300_500_800_e.book 53 ページ ２００６年１２月１９日 火曜日 午後２時５９分