Filter
Top Products
39
Playing (Play mode)
You can set the controllers to the desired positions and then transmit their state as a
“snapshot.”
The snapshot function will transmit the current values of the controllers [R1]–[R9], [S1]–
[S9], and [H1]–[H2] in a single operation.
This is a convenient way to send control data to your DAW software. You can
use this to record initial values at the beginning of your song.
fig.H-SNAP.eps
1
Simultaneously press the [PRM MUTE] button
and OCTAVE [-] button.
The [PRM MUTE] ([ENTER]) button will blink.
2
Press the [ENTER] button.
The [PRM MUTE] button will blink several times.
This completes transmission of the snapshot.
You can mute all controllers so that they will not transmit MIDI messages even if they
are moved.
If a parameter value is distant from the current physical position of a controller,
you can avoid an unwanted sudden jump in the value by using the [PRM MUTE]
button to mute the controllers before moving the controller to a position that’s
close to the current value.
fig.H-PRMMute.eps
1
Press the [PRM MUTE] button.
The [PRM MUTE] button will light, and the
display will indicate “P ON.”
fig.D-PRMOn.eps
2
Operate the controllers.
At this time, MIDI messages will not be transmitted when you move
the controllers.
fig.D-PRMOff.eps
3
Press the [PRM MUTE] button once again.
The [PRM MUTE] button will go out, and the display will indicate
“POFF.”
Now, when you move the controllers, MIDI messages will once again be transmitted.
Sending the current value of all controllers
(Snapshot)
Snapshot
Muting the controller values
(PRM MUTE)
PRM MUTE
PCR-300_500_800_e.book 39 ページ ２００６年１２月１９日 火曜日 午後２時５９分