Filter
Top Products
166
Sample Mode
2.
Select the location (sample number) that you wish to sample.
Move the cursor to the desired sample. Normally, you will select a sample that has no wave; i.e., a sample number
whose name is “NO SAMPLE.”
In this screen you can use the following functions.
• Select a sample by directly touching it.
• Change the number in steps of eight by pressing [ ] [ ].
• Change the number in steps of one by touching < >< >, located beside the sample list, by pressing
[ ] [ ] [INC/+] [DEC/-], or by turning the VALUE dial.
• Scroll the sample list by dragging the scroll bar located beside the sample list up or down.
• Move to the number 001 sample by touching <Top>.
• Move to the number 999 sample by touching <End>.
• Display information on the currently selected sample by touching <Info> (p. 192). However, this information
will not be displayed for the factory-set waves.
• Audition the currently selected sample by touching <Prevw>.
• When you touch <Search Empty>, you will jump to the “NO SAMPLE” sample number that follows the
current sample number.
3.
Touch <Sampling>.
The Sampling Template screen appears.
fig.04-02_50
4.
Touch <TMPL 1>–<TMPL 8> to select a sampling template.
If you want to modify the settings of the selected sampling template, perform the following steps 5–7.
5.
Touch one of the tabs displayed at the bottom of the screen to access the corresponding setting screen.
<General>: Setup settings (p. 174)
<Pre-Effect>: Pre-effect settings (p. 175)
<Metronome>: Metronome settings (p. 176)
For details on each parameter, refer to the page references given.
6.
In each setting screen, touch the touch panel to set the parameters.
Move the cursor to the value box of the parameter you want to edit, and use any of the following methods to edit it.
• Turn the VALUE dial
• Press [INC/+] or [DEC/-]
• Drag your fingertip on the touch panel
V-Synth-GT_e.book 166 ページ ２００７年４月９日 月曜日 午後１時４６分