Filter
Top Products
18
Getting Ready
941
Once you’ve made connections correctly (see preceding page), turn on the power using the following procedure.
Powering up your equipment in the wrong order may cause malfunctions or speaker damage.
Be careful not to set your listening volume too high to avoid damage to your amp/speaker system or your hearing.
To ensure proper operation of the pitch bend lever, make sure not to touch the lever when
turning the V-Synth GT’s power on.
1.
Before turning on the V-Synth GT’s power, consider these two questions:
• Are all peripheral devices connected correctly?
• Have the volume controls of the V-Synth GT and all connected audio devices been turned
to their lowest settings?
2.
Turn on the POWER ON switch located on the rear panel of the V-Synth GT.
fig.01b-002-j.eps
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate
normally.
3.
Turn on the power for any connected amplifiers or speakers.
4.
Wait for the V-Synth GT to start up. When it has started up normally, a screen like the following will appear.
fig.patch-ps.eps
Turning On the Power
Do not touch!
ON OFF
V-Synth-GT_e.book 18 ページ ２００７年４月９日 月曜日 午後１時４６分