Filter
Top Products
89
Editing a Tone (Pro Edit)
Com MOD COSM1/2 TVAOSC1/2 AP Syn Effects
4.
Specify the split point between zones 01 and 02. Either turn the VALUE dial or use [INC/+] [DEC/-] to specify the
note number.
If you want to divide the keyboard into three zones, lower the top note of zone 02, and specify the split point
between zones 02 and 03. By lowering the top note of the highest zone in this way, you can add more zones. You
can specify a maximum of sixteen zones.
5.
Touch <OK>.
The zones will be established, and you will return to the Pro Edit screen.
6.
In this state, zone 01 is selected. Specify the sound that you want to play in zone 01.
7.
After you have specified the sound that you want to play in zone 01, next specify the sound for zone 02.
8.
Specify the sound that you want to play in zone 02.
In this way you can create a patch that plays different sounds on either side of the split point you specified in step
4.
Each zone works just like a single tone. You can create the sound for a zone from scratch in the same way as for a
tone, as described in the procedure
“Editing a Tone (Pro Edit)”
(p. 85).
9.
To save the patch you created, perform the Write operation (p. 81).
V-Synth-GT_e.book 89 ページ ２００７年４月９日 月曜日 午後１時４６分