Filter
Top Products
190
Sample Mode
Setting the Encode Depth and automatically detecting events does not guarantee that the events will be added at the
locations that you expect. If necessary, you can delete or add events as you like.
In the Sample Encode screen, you can touch <PREVIEW> to play the sample from the current location until the next
event.
By touching <PREVIEW>, you can play the sample to see whether events have been assigned to the locations that you
expect.
Be aware that if you change the encode depth after deleting or adding events, the events that were modified
manually will be discarded, and the events that were detected by depth will be displayed.
If you modify the location of events after encoding, you must re-encode. The modified location of the events will take
effect when you encode.
Deleting an Event
1.
Move the cursor to “Current.”
2.
By turning the VALUE dial, pressing [INC/+] [DEC/-], or dragging your finger over the sample in the screen, set
Current to the location of the event that you want to delete.
3.
Touch either or .
The Current location will move to the location of the next event toward the left or right.
4.
Repeat step 3 to move Current to the location of the event that you wish to delete.
5.
Touch to delete the event.
The events at the beginning and end of a sample cannot be deleted.
Adding an Event
1.
Move the cursor to “Current.”
2.
By turning the VALUE dial, pressing [INC/+] [DEC/-], or dragging your finger over the sample in the screen, move
Current to the location at which you want to add the event.
3.
Touch to add the event.
Deleting and Adding Events
V-Synth-GT_e.book 190 ページ ２００７年４月９日 月曜日 午後１時４６分