Filter
Top Products
189
Sample Mode
By specifying the Depth, you can automatically detect and “
▼
”mark locations where there is a strong attack (i.e.,
locations where the volume changes abruptly). Such marked locations are called events.
fig.04-22
Automatically Detecting Events
Parameter
Value Description
Depth (Encode Depth)
0–127
In the Sample Encode screen, move the cursor to “Depth” and set the value.
The higher the value you set, the more events will be assigned.
If the Playback Mode (p. 99) is “STEP,” the sample will play to the next
event, and then stop each time you play the key. When the Playback Mode
is set to “EVENT,” the sample will be divided at event locations, and
assigned to each key.
• If you set Depth to a high value, a large number of events may
be detected. If you encode in such a state, the interval
between events will be too short, and the expected result will
not be obtained when you play back in event units.
• If you change the location of an event after encoding, you
must re-encode the sample. When you encode, the newly
detected event locations will take effect.
V-Synth-GT_e.book 189 ページ ２００７年４月９日 月曜日 午後１時４６分