Filter
Top Products
180
Sample Mode
(LENGTH LOCK)
This locks the length of the region between the start point (Start) and end point (End) of the sample. It is convenient to
use this when you already know the length of the sample that you need, and want to find the right region to use.
After the length has been locked, you can turn the VALUE dial, use [INC/+] [DEC/-], or drag your finger over the
sample in the screen to adjust the Start and End locations while maintaining the distance between these two points.
You can also use Adjust or Zero Cross Search while the length of the sample is locked.
(LOOP)
This switches loop playback on/off. Turn this on if you want the loop region specified in the Loop FWD/BWD screen
to play repeatedly.
(PREVIEW)
This plays the sample. During playback, you can touch this once again to stop playback.
(Adjust)
In the Loop FWD/BWD screen, the Adjust function moves the Loop Start, Loop End, or Current locations to the nearest
of the following locations 1–5.
In edit screens, the Adjust function moves the Edit Start, Edit End, or Current locations to the nearest of the following
locations 1–7.
Move the cursor to the point that you want to adjust (“Start,” “End,” or “Current”), and touch or .
Touching will move the point toward the left, and touching will move it toward the right.
In the Sample Encode screen (p. 187), this will move the Current location to the closest event.
For example, if you wish to touch <PREVIEW> to check whether the results of your editing were satisfactory, you can
jump the current location.
In some cases nothing may happen, due to the relation between points or the Length Lock setting.
1 Sample Start location
2 Sample End location
3 Loop Start location
4 Loop End location
5 Current location
6 Edit Start location
7 Edit End location
V-Synth-GT_e.book 180 ページ ２００７年４月９日 月曜日 午後１時４６分