Filter
Top Products
207
System Mode (Settings Common to All Modes)
fig.08-18.eps_50
Pedal
Parameter
Value Description
Hold Polarity
(Hold Pedal Polarity)
Standard, Reverse
Selects the polarity of the Hold pedal. On some pedals,
the electrical signal output by the pedal when it is pressed
or released is the opposite of other pedals. If your pedal
has an effect opposite of what you expect, set this param-
eter to “Reverse.” If you are using a Roland pedal (that
has no polarity switch), set this parameter to “Standard.”
Pedal 1, 2 Assign
This specifies the function of each
pedal connected to the CTRL 1,
CTRL 2 PEDAL jacks.
OFF The control pedal will not be used.
CC01–31, 33–95 Controller numbers 1–31, 33–95
BEND UP Pitch bend (positive direction)
BEND DOWN Pitch bend (negative direction)
AFT Aftertouch
VALUE INC The pedal will perform the same operation as pressing
[INC/+]. This is convenient when you want to switch
patches or tones while performing.
VALUE DEC The pedal will perform the same operation as pressing
[DEC/-]. This is convenient when you want to switch
patches or tones while performing.
Pedal 1, 2 Polarity
Standard, Reverse
Selects the polarity of the pedal. On some pedals, the
electrical signal output by the pedal when it is pressed or
released is the opposite of other pedals. If your pedal has
an effect opposite of what you expect, set this parameter
to “Reverse.” If you are using a Roland pedal (that has no
polarity switch), set this parameter to “Standard.”
V-Synth-GT_e.book 207 ページ ２００７年４月９日 月曜日 午後１時４６分