Filter
Top Products
72
Patch Mode (Editing a Patch)
Pattern Input Area
This area is where you input or edit notes or control changes. The symbols have the follow-
ing meaning:
●
: Note
=: Tie
❍
: Control change
Value
Shows the velocity of the note or the value of the control change selected in the pattern input
area.
0, 32, 64, 96, 127,
Tie/Clr
When inputting notes:
When you touch one of these buttons, a note with the velocity shown
on that button will be input at the cursor location within the pattern input area. When you
touch <Tie>, a tie will be input at the cursor location.
When inputting control changes:
A control change with the value shown on that button will
be input at the cursor location within the pattern input area. When you touch <Clr>, the
selected control change will be erased.
When you are editing, these buttons modify the velocity of the note that is selected in the
pattern input area, or the value of the control change.
You can also input the note velocity or control change value by using the VALUE dial or
[INC/+] [DEC/-].
Grid
Specifies the note value that will correspond to “one step” of the arpeggio pattern.
End Point
Specifies the pattern length as a number of steps (1–32).
Clear
Erases the pattern data (p. 75).
Real Rec
(Realtime Recording)
Uses realtime recording to create a pattern (p. 73).
Step Rec
(Step Recording)
Uses step recording to create a pattern (p. 74).
(Thirty-second note)
(Dotted eighth note),(Eighth note),(Quarter note),
(Sixteenth note), (Dotted sixteenth note),
V-Synth-GT_e.book 72 ページ ２００７年４月９日 月曜日 午後１時４６分