Filter
Top Products
DDK-7 Owner’s Manual
219
Internet Direct Connection
12
LAN
In this display page, you can make settings for the LAN connection. These settings are
needed for not only wired LAN connection but also wireless LAN connection.
1 Use DHCP
Determines whether or not DHCP is used. If your router is compatible with DHCP,
select “ON (set DNS automatically)” here.
2 DNS server 1 / DNS server 2
These determine the addresses of the primary and secondary DNS servers. These
settings must be made when “Use DHCP” above is set to “ON (set DNS manually)” or
“OFF.”
3 IP address / Subnet mask / Gateway
These settings are available only when DHCP is not used. The settings here are: IP
address, subnet mask, and gateway server address. These settings must be made when
“Use DHCP” above is set to “OFF.”
Wireless LAN
In this display page, you can make settings for the wireless LAN connection. These
settings must be the same as the settings on the Access Point.
1
2
3
Make a written note of these settings, in case you
have to enter the settings again.
Use DHCP
DNS server 1
DNS server 2
IP address
Subnet mask
Gateway
1
2
3
5
4
Make a written note of these settings, in case you
have to enter the settings again.
SSID
Channel Ch
Encryption On Off
WEP key type ASCII Hexadecimal
WEP key length 64 bit 128 bit
WEP key