Filter
Top Products
4
Voice Controls and Effects
DDK-7 Owner’s Manual
42
3 PITCH
Controls pitch according to the play style of After Touch.
AFTER touch
Controls the pitch according to the pressure you apply to the keys after playing
them.
The minimum setting produces no effect at all. Higher (positive) settings make
the pitch higher according to the pressure and lower (negative) settings make the
pitch lower. The setting of +14 or -14 results in the widest pitch change.
Range: -14 – +14
4 FEET
Determines the octave setting of the Voice, letting you use the Voice over a wide
register. There are three settings: 4', 8' and 16' (4' is highest and 16' is lowest). A 2'
setting is added to the Pedal Voice sections. PRESET is the original (factory) setting.
5 REVERB
Determines the amount of reverb applied to each Voice section. When the REVERB
control in the Reverb Page 1 is set to the minimum, the setting here will have no effect.
See page 46 for details.
6 BRILLIANCE
Adjustment of the Voice tone, brighter or mellower. Range is from -3 to +3. Higher
settings makes the voice tone brighter.
7 VOLUME
Fine adjustment of the Voice volume. See page 28 for more information.
8 PRIORITY (only for the Lead Voice 2)
Determines the mode of Lead Voice 2, Last or Top.
LAST: Only the last played key is sounded when two or more keys are played
simultaneously.
TOP: Only the highest note is sounded when two or more keys are played
simultaneously. When the Solo mode is on, Lead Voice 2 sounds according to
Last mode, regardless of the setting made here.
9 POLY (only for Pedal Voices)
Allows you to switch the pedal polyphonic mode on or off. Setting POLY to on
switches the normally monophonic pedal Voices to polyphonic play. This makes it
possible to play the Pedalboard in various expressive ways, such as playing legato or
playing intervals and chords.
Keep in mind that you cannot exceed the total maximum polyphony: 14 notes for all
sections, Upper, Lower and Pedal.
Reference Page
Solo function (page 30)