Hewlett-Packard 8200ZL Manual

A SERVICE OF

next previous

router

OVERVIEW

RoutingCategory:

configPrimary context:

ip (page 290)Related Commands

vlan (page 706)

show (page 511)

Usage: [no] router ...

Description: Congure the switch routing protocols. You can enter the commands from the

global conguration context

or the RIP, OSPF, PIM, or VRRP conguration contexts. For example, to enter

an OSPF command from the

global conguration context, use the "router" keyword in front of the

command. To enter an OSPF

command in the OSPF conguration context, type "router ospf" to change to

the OSPF conguration

context, then type the command without the "router" keyword.

Use 'router ?' to see a list of all possible options.

COMMAND STRUCTURE

■ [no] router ospf -- Enable/disable/configure Open Shortest Path First (OSPF) protocol on the device,

or enter OSPF Configuration Context (p. 483)

■ area -- Define/remove an OSPF area, area range or virtual link (p. 474)

■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p. 476)

■ normal -- Define a "normal" area. (p. 482)

■ nssa < 0 to 16777215 > -- Define a "not-so-stubby" area (or NSSA) and its cost. (p. 483)

■ metric-type < type1 | type2 > -- Metric type of the type-7 default. (p. 482)

■ no-summary -- Do not send summary LSA into the area. (p. 482)

■ range -- Summarize routes matching address/MASK pair. (p. 484)

■ ip -- Specify IP address/MASK pair. (IP-ADDR/MASK-LENGTH) (p. 481)

■ no-advertise -- Do not advertise the range outside the area. (p. 482)

■ type < summary | nssa > -- Link state database type to apply the range. (p. 491)

■ stub -- Define a "stub" area and specify its cost. (p. 489)

■ cost < 0 to 16777215 > -- Enter cost to use when injecting default routes into the

area. (p. 478)

■ no-summary -- Do not send summary LSA into the area. (p. 482)

■ virtual-link -- Specify a virtual neighbor. (IP-ADDR) (p. 492)

■ authentication -- Disable authentication. (p. 476)

■ authentication-key -- Set simple authentication method and key. (p. 476)

■ authentication-key -- OSPF authentication key (maximum 8 characters).

(OCTET-STR) (p. 476)

■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40. (p. 478)

■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10. (p. 480)

■ md5-auth-key-chain -- Set MD5 authentication method and key chain. (p. 481)

■ chain-name -- Specify key chain to use for MD5 authentication. (ASCII-STR) (p.

478)

471© 2009 Hewlett-Packard Development Company, L.P.