Dr, or Backup).
- 'virtual-interface-state-change' signies the same change in the
state of a virtual OSPF interface.
- 'neighbor-state-change' signies that there has been a change in
the state of a non-virtual OSPF neighbor. This trap is generated
when the neighbor state regresses (e.g., goes from Attempt or Full
to 1-Way or Down) or progresses to a terminal state (e.g., 2-Way
or Full).
- 'virtual-neighbor-state-change' signies the same change in the
state of a virtual OSPF neighbor.
- 'interface-cong-error' signies that a packet has been received
on a non-virtual interface from a router whose conguration
parameters conict with this router's conguration parameters.
- 'virtual-interface-cong-error' signies the same condition on a
virtual interface.
- 'interface-authentication-failure' signies that a packet has
been received on a non-virtual interface from a router whose
authentication key or authentication type conicts with this
router's authentication key or authentication type.
- 'virtual-interface-authentication-failure' signies the same
condition on a virtual interface.
- 'interface-receive-bad-packet' signies that an OSPF packet has
been received on a non-virtual interface that cannot be parsed.
- 'virtual-interface-receive-bad-packet' signies the same
condition on a virtual interface.
- 'interface-retransmit-packet' signies than an OSPF packet has
been retransmitted on a non-virtual interface.
- 'virtual-interface-retransmit-packet' signies the same condition
on a virtual interface.
- 'originate-lsa' signies that a new LSA has been originated by
this router. This trap is not invoked for simple refreshes of
LSAs, but instead will only be invoked when an LSA is
(re)originated due to a topology change. Additionally, this trap
does not include LSAs that are being ushed because they have
expired.
- 'originate-maxage-lsa' signies that one of the LSA in the
router's link-state database has expired.
If 'all' is specied in place of a trap name then all the traps
are affected by the command.
Supported Values:
■ virtual-interface-state-change
■ neighbor-state-change
■ virtual-neighbor-state-change
■ interface-config-error
■ virtual-interface-config-error
■ interface-authentication-failure
■ virtual-interface-authentication-failure
■ interface-receive-bad-packet
■ virtual-interface-receive-bad-packet
■ interface-retransmit-packet
■ virtual-interface-retransmit-packet
■ originate-lsa
■ originate-maxage-lsa
■ interface-state-change
■ all
■ [no] router pim trap < neighbor-loss | hardware-mrt-full | software-mrt-full | ... >
490© 2009 Hewlett-Packard Development Company, L.P.
routerCommand Line Interface Reference Guide
