Enter a list of protocols for the current VLAN delimited by commas.
protocols
■ [no] vlan VLAN-ID protocol < IPX | IPv4 | IPv6 | ... >
Set a predened protocol for the current VLAN.
Supported Values:
■ IPX -- IPX Protocol Group
■ IPv4 -- IP version 4 Protocol Group
■ IPv6 -- IP version 6 Protocol Group
■ ARP -- Address Resolution Protocol Group
■ Appletalk -- Appletalk Protocol Group
■ SNA -- System Network Architecture Protocol Group
■ NetBEUI -- Network BIOS Enhanced User Interface Protocol Group
proxy-arp
■ [no] vlan VLAN-ID ip proxy-arp
Usage: [no] ip proxy-arp
Description: Enable/disable proxy ARP. This is a VLAN context command.
It can be called directly from the VLAN context or may follow
the 'vlan VLAN-ID' command prex. When proxy ARP is enabled on
a VLAN, the device responds to ARP requests received on the
VLAN ports when the device knows a route to the requested IP
addresses.
qos
■ [no] vlan VLAN-ID qos
Usage: [no] qos [dscp <0|1...63|af11|af12|af13|af21|af22|af23|af31|af32|
af33|af41|af42|af43|ef|cs0..cs7|000000|000001...111111> |
priority <0-7>]
Description: Set VLAN-based priority. The 'dscp' or 'priority' must
be specied if 'no' is not used. Using 'no' congures
the switch not to apply a VLAN priority override to this
VLAN's packets.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Next Available Options:
■ dscp -- Specify DSCP policy to use. (p. 722)
■ priority < 0 | 1 | 2 | ... > -- Specify priority to use. (p. 742)
querier
■ [no] vlan VLAN-ID ip igmp querier
Usage: [no] ip igmp querier [interval <seconds>]
Description: Specify querier/non-querier capability for the VLAN. IGMP
queries are not sent when the mode is disabled. When
744© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
