■ spf-log -- List the OSPF SPF(Shortes Path First Algorithm) run count for all OSPF areas and last
ten Reasons for running SPF(p. 593)
■ statistics -- List OSPF packet statistics( OSPF sent,recieved and error packet count) of all OSPF
enabled interfaces(p. 594)
■ area -- Show OSPF areas configured on the device(p. 529)
■ external-link-state -- Show the Link State Advertisements from throughout the areas to which
the device is attached(p. 550)
■ interface -- Show OSPF interfaces' information(p. 559)
■ link-state -- Show all Link State Advertisements from throughout the areas to which the device
is attached(p. 565)
■ neighbor -- Show all OSPF neighbors in the locality of of the device(p. 573)
■ redistribute -- List protocols which are being redistributed into OSPF(p. 584)
■ restrict -- List routes which will not be redistributed via OSPF(p. 586)
■ traps -- Show OSPF traps enabled on the device(p. 599)
■ virtual-neighbor -- Show all virtual neighbors of the device(p. 603)
■ virtual-link -- Show status of all OSPF virtual links configured(p. 603)
output
■ show bandwidth output
Show outbound guaranteed minimum bandwidth.
Next Available Option:
■ port-list -- Specify ports for which information will be shown. ([ethernet] PORT-LIST) (p. 578)
PARAM-NAME
■ show snmpv3 params PARAM-NAME
Show a specic Target Parameter entry.
params
■ show snmpv3 params
Show SNMPv3 Target Parameters table.
Next Available Option:
■ PARAM-NAME -- Show a specific Target Parameter entry. (ASCII-STR) (p. 575)
peer
■ show ip rip peer
Usage: show ip rip peer [IP-ADDR]
Description: Show RIP peers. Invoked without parameters shows all RIP
peers of the device. If 'IP-ADDR' is specied only
the peer having the address is displayed.
Next Available Option:
■ peer-ip -- Specify IP address of the RIP peer to show. (IP-ADDR) (p. 576)
575© 2009 Hewlett-Packard Development Company, L.P.
showCommand Line Interface Reference Guide
