Filter
Top Products
Chapter 2. Installing 3Com VCX IP Telecommuting Module
Telecommuting Module). The network mask determines the number of computers that can act as configuration
computers.
Network number [0.0.0.0]: 10.47.2.0
Netmask/bits [255.255.255.0]: 255.255.255.0
If the network or partial network is not directly connected to the Telecommuting Module, you must enter the IP
address of the router leading to that network. Then enter the network’s address and mask.
Static routing:
The network allowed to configure from is not on a network local to this
unit. You must configure a static route to it. Give the
IP address of the router on the network this unit is on.
The IP address of the router [0.0.0.0]: 10.47.3.1
Network address [10.47.0.0]: 10.10.0.0
Netmask [255.255.255.0]:
Then enter a password.
Password []:
Finally, you are asked if you want to reset other configuration.
Other configuration
Do you want to reset the rest of the configuration? (y/n) [n]
If you answer n, nothing is removed. If you answer y, you have three alternatives to select from:
1. Clear as little as possible. This is the alternative that is used if you answer n to the question above. Both the
preliminary and the permanent configurations will be updated with the configuration specified above.
2. Revert to the factory configuration and then apply the configuration specified above. This will affect the
permanent but not the preliminary configuration.
3. Revert to the factory configuration and empty all logs and then apply the configuration specified above. Both
the preliminary and the permanent configurations will be affected.
Select the update mode, which is what you want to remove.
Update mode (1-3) [1]:
All configuration is now complete. The installation program shows the configuration and asks if it is correct.
yes saves the configuration.
no runs the installation program over again.
abort ends the installation program without saving.
8