Filter
Top Products
Chapter 3. Configuring 3Com VCX IP Telecommuting Module
logging wanted under Logging. This is also where the logs of traffic through the Telecommuting Module are
viewed.
When the configuration is complete, apply it. Go to Save/Load Configuration under Administration. Select
Apply configuration. Now the new configuration is tested. Save it permanently if it works satisfactorily. If the
configuration is not satisfactory, select Revert or restart the Telecommuting Module. The old configuration will
remain.
Preliminary and permanent configuration
3Com VCX IP Telecommuting Module has two kinds of settings: preliminary and permanent configuration. When
the Telecommuting Module is running, the permanent configuration controls the Telecommuting Module functions.
When you configure your Telecommuting Module, you are working with the preliminary configuration. As you
change the preliminary configuration, the permanent configuration continues to control the Telecommuting Module
functions.
When you are done with the preliminary configuration, you can test it by selecting Apply configuration on the
Save/Load Configuration page. Now the preliminary configuration controls the Telecommuting Module functions.
When you are satisfied with the preliminary configuration, you can apply it permanently, which copies the
preliminary configuration to the permanent configuration. Now the new configuration controls the Telecommuting
Module functions.
You can also copy the permanent configuration to the preliminary configuration. This does not affect the permanent
configuration or the Telecommuting Module functions, which are still being run by the permanent configuration.
You do this by selecting Abort all edits on the Save/Load Configuration page under Administration. This will
discard all changes made in the preliminary configuration since last time you applied a configuration by pressing
Save configuration.
16