Filter
Top Products
Chapter 9. SIP Traffic
Domain
Enter the domain name of the SIP domain.
Relay to
Enter the IP address for the SIP registrar handling the domain. You can also enter a DNS name for the SIP registrar,
if it has a DNS-resolvable host name, even if the SIP domain is not possible to look up in DNS.
Under Port, enter the port on which the SIP registrar listens for SIP traffic. The standard port is 5060 (5061 for
TLS).
You can select which transport protocol to use between the Telecommuting Module and the registrar. Under
Transport, select from UDP, TCP and TLS. You can also select "-", which means that the signaling is passed on
using the same transport as was used to reach the Telecommuting Module.
If you entered more than one IP address/host name for the same domain, you should also assign them Priority and
Weight. A low Priority value means that the unit should have a high priority. If more than one unit has the same
Priority, the signaling sent to them is distributed between them according to their Weight. If two units have the
same priority, and Unit 1 has weight 4, and Unit 2 has weight 9, 4/13 of the signaling will be sent to Unit 1, and
9/13 will be sent to Unit 2.
Delete Row
If you select this box, the row is deleted when you click on Add new rows, Save, or Look up all IP addresses
again.
Create
Enter the number of new groups and rows you want to add to the table, and then click on Create.
Save
Saves the Routing configuration to the preliminary configuration.
Cancel
Reverts all of the above fields to their previous configuration.
Look up all IP addresses again
Looks up the IP addresses for all DNS names on this page in the DNS servers you entered on the Basic
Configuration page.
85