Filter
Top Products
19
Chapter 2
Operation
recorded, without passing through the fader or EQ.
10. Combining multiple
tracks into one or two
tracks (Bounce)
The performance of multiple tracks can be com-
bined into one or two tracks, freeing the original
tracks for additional recording. This operation is
called “track bouncing” or “ping pong recording”.
This can be used when you wish to record more
than 8 tracks, etc.
As an example, we will show how you can com-
bine the performances of tracks 1–5 to track 6. We
will also explain how you can combine tracks 1–5
to tracks 7 and 8 in stereo.
■ Playback track and recording track settings
1 Press the [REC SELECT] key several
times to select INPUT 1/2 + MASTER
(both indicators lit). With a setting of
INPUT 1/2 + MASTER, you can use
the master bus as the input for record-
ing.
2 Press the [TRACK STATUS] keys for tracks 1–5
several times to set each one to PLAY (indicator lit
green), to select these as playback tracks. Press the
track 6 [TRACK STATUS] key several times to
select REC (ANALOG) (indicator blinking red), to
select it as the recording track.
✧ If you are combining the other tracks to tracks 7
and 8 in stereo, press the track 7/8 [TRACK STA-
TUS] key several times to select REC (ANALOG)
(indicator blinking red).
3 Track 6 (the recording track) uses the “R” bus
(printed on the [TRACK STATUS] key). Rotate the
[PAN] knobs of tracks 1–5 to the far right position
(R), so that their sound will be sent to the right
channel.
When bouncing to a single track, be sure to set the
[PAN] knobs of the bounce source tracks to match
the indication of either “L” or “R” shown above
the [TRACK STATUS] key of the bounce destina-
tion track.
✧ If you are combining tracks 1–5 in stereo to tracks 7
and 8, rotate the [PAN] knobs of tracks 1–5 to place
each track at the desired stereo location.
Track 1
Track 2
Track 3
Track 4
Track 5
Track 6 (1+2+3+4+5)
REC
SELECT
INPUT 1/2
MASTER
DIGITAL I
N
lit green
5
L
blinking red
1
L
6
R
PAN
LR
1
PAN
LR
5
Recording