Filter
Top Products
64
30. EFFECT ASSIGN
Effect insert location select[.................................INPUT 1/2,
MASTER (Send Type), MASTER (Global Type), OFF]
Selects the location at which the internal effect will be
inserted.
INPUT 1/2: The internal effect will be
inserted between the EQ and the fader
of mixer channels whose [TRACK
STATUS] is set to REC (ANALOG).
(Refer to p.70)
Use this setting when you wish to
apply an insertion-type effect during
recording.
The “Snd” (refer to “23. EFFECT SEND”) for each
channel will automatically be turned off.
MASTER (Send Type): The signals
(send bus) which are sent from the
“Snd” (refer to EFFECT SEND) of
each mixer channel will be sent to
the internal effect, and the effect
will be inserted as a master effect
which outputs to the master bus.
(Refer to p.69) Since the signal sent
to the effect is monaural, there may be cases in which
the desired result will not occur even if a stereo-input
type effect is selected.
Use this setting when you wish to apply a master-type
effect during playback or recording, or to apply an
insertion-type effect to the playback while recording it.
The “Snd” (refer to “23. EFFECT SEND”) of each chan-
nel is set manually.
MASTER (Global type): The out-
put of the master bus will be sent to
the internal effect, and the effect
will be inserted as a master effect
before the master fader. (Refer to
p.70)
Use this setting when you wish to
apply an effect such as a stereo compressor etc. to the
entire song during mixdown.
The “Snd” (refer to “23. EFFECT SEND”) of each chan-
nel is turned off automatically.
OFF: The audio return from the inter-
nal effect will be turned off.
The effect return level setting (refer to
“EDIT EFFECT ASSIGN P1”) will be
ignored.
31. EDIT EFFECT ASSIGN
Effect return level setting
P1-1 Effect return level setting..........................[000...100]
Sets the volume of the signal that is returned from the
internal effect.
Effect return balance setting
P2-1 Effect return balance setting.........[L50...CNT...R50]
Sets the left/right balance of the signal that is returned
from the internal effect.
External input (AUX IN) level setting
P3-1 External input (AUX IN) level setting ........[000...100]
Sets the input volume level of the external input (AUX
IN).
External input (AUX IN) balance setting
P4-1 External input (AUX IN) balance setting ...........
[L50...CNT...R50]
Sets the left/right balance of the signal from the exter-
nal input (AUX IN).
EFFECT
ASSIGN
INPUT 1/2
MASTER
E
EFFECT
ASSIGN
INPUT 1/2
MASTER
E
lit
EFFECT
ASSIGN
INPUT 1/2
MASTER
E
blinking
EFFECT
ASSIGN
INPUT 1/2
MASTER
E
P1
1
EffRet:000
P2
1
EffBal:CNT
P3
1
AuxRet:000
P4
1
AuxBal:CNT