3 - 50
CHK
ADJ
CHECKING THE COOLANT LEVEL
EAS00102
CHECKING THE COOLANT LEVEL
1. Stand the motorcycle on a level surface.
NOTE:
@
• Place the motorcycle on a suitable stand.
• Make sure the motorcycle is upright.
2. Remove:
• right side cowling
Refer to “COWLINGS AND COVERS”.
3. Check:
• coolant level
The coolant level should be between the
maximum level mark
a
and minimum level
mark
b
.
Below the minimum level mark
→
Add the
recommended coolant to the proper level.
CAUTION:
@
• Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant check,
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available soft water may
be used.
4. Start the engine, warm it up for several min-
utes, and then turn it off.
5. Check:
• coolant level
NOTE:
@
Before checking the coolant level, wait a few
minutes until it settles.
6. Install:
• side cowling (right)
Refer to “COWLINGS AND COVERS”.
