A SERVICE OF

logo

4 - 51
CHAS
EAS00309
EAS00310
ASSEMBLING AND INSTALLING THE
CLUTCH MASTER CYLINDER
WARNING
@
Before installation, all internal clutch
components must be cleaned and lubri-
cated with clean or new clutch fluid.
Never use solvents on internal clutch
components as they will cause the piston
seals to swell and distort.
Recommended clutch fluid
Brake fluid DOT 4
1. Install:
clutch master cylinder
1
NOTE:
@
Install the clutch master cylinder holder with
the “UP” mark facing up.
Align the end of the clutch master cylinder
holder with the punch mark
a
in the left han-
dlebar.
• First, tighten the upper bolt, then the lower
bolt.
T
R
.
.
10 Nm (1.0 m · kg)
2. Install:
copper washers
1
clutch hose
2
union bolt
3
WARNING
@
Proper clutch hose routing is essential to
insure safe motorcycle operation. Refer to
“CABLE ROUTING”.
New
T
R
.
.
30 Nm (3.0 m · kg)
HYDRAULIC CLUTCH