A SERVICE OF

logo

5 - 118
ENG
INSTALLING THE TRANSMISSION
1. Install:
main axle assembly
shift fork “C”
shift drum assembly
shift fork “R”
shift fork “L”
shift fork guide bars
shift drum retainer
drive axle assembly
NOTE:
@
When installing the main axle assembly, use
a pin to align the bearing housing bolt hole
with the corresponding hole in the upper
crankcase.
The embossed marks on the shift forks
should face towards the right side of the
engine and be in the following sequence:
“R”, “C”, “L”.
Make sure the drive axle bearing circlip 1 is
inserted into the grooves a in the upper
crankcase.
The drive axle bearing pin 2 must face
towards the rear of the crankcase.
T
R
.
.
12 Nm (1.2 m · kg)
T
R
.
.
10 Nm (1.0 m · kg)
2. Check:
transmission
Rough movement Repair.
NOTE:
@
Oil each gear, shaft, and bearing thoroughly.
TRANSMISSION