A SERVICE OF

logo

5 - 17
ENG
CAMSHAFTS
d. Remove the screwdriver, make sure the tim-
ing chain tensioner rod releases, and then
tighten the cap bolt to the specified torque.
▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲
T
R
.
.
Cap bolt
10 Nm (1.0 m · kg)
6. Turn:
crankshaft
(several turns clockwise)
7. Check:
•“T mark a
Make sure the “T” mark a on the pickup
coil rotor is aligned with the crankcase mat-
ing surface b.
camshaft holes c
Make sure the holes c in the cylinder #4 -
cam are aligned with the arrow marks d on
the camshaft caps.
Out of alignment Adjust.
Refer to the installation steps above.
8. Measure:
valve clearance
Out of specification Adjust.
Refer to “ADJUSTING THE VALVE
CLEARANCE” in chapter 3.