3 - 62
CHK
ADJ
ADJUSTING THE SHIFT PEDAL/CHECKING THE FINAL
DRIVE OIL LEVEL/CHANGING THE FINAL DRIVE OIL
NOTE:
Make sure that the mark on the shift pedal is
between the marks on the frame.
c. Tighten both locknuts.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS00144
CHECKING THE FINAL DRIVE OIL LEVEL
1. Stand the motorcycle on a level surface.
NOTE:
@
• Place the motorcycle on a suitable stand.
• Make sure the motorcycle is upright.
2. Remove:
• final drive housing oil filler bolt 1
3. Check:
• final drive oil level
The final drive oil level should be to the bot-
tom brim 1 of the filler hole.
Below the bottom brim → Add the recom-
mended final drive oil to the proper level.
4. Install:
• final drive housing oil filler bolt
Recommended oil
Drive shaft gear oil
T
R
.
.
23 Nm (2.3 m · kg)
EAS00145
CHANGING THE FINAL DRIVE OIL
1. Place a container under the final drive
housing.
2. Remove:
• final drive housing oil filler bolt 1
• final drive housing oil drain bolt 2
Completely drain the final drive housing of
its oil.
