A SERVICE OF

logo

Installing Riv-Nut ports in the FJR's Headers
First a hole is drilled into the pipe where the port is required. European and
Oceanic models have ports installed from the factory. Migmagal reports they are
located "About 5 inches after the cylinder exits on each tube" and Woody concurs
saying they are "about 125mm from the top of the exhaust ports". For clarity,
these pictures are of a sample installed on a piece of scrap 1 1/2" exhaust pipe.
http://www.micapeak.com/bike/FJR1300/howto/rivnut.html (3 of 10) [15/05/2003 5:56:43 PM]