A SERVICE OF

logo

Open as PDF
next previous
Installing Riv-Nut ports in the FJR's Headers
The hole is sealed with a bolt when not in use. As can be seen from this picture,
the bolt may protrude into the pipe unless cut to length. Besides being a
potential for further restriction, the exposed threads could become clogged with
carbon deposits from the exhaust making future removal difficult or impossible. I
suggest trimming the bolt to avoid problems.
http://www.micapeak.com/bike/FJR1300/howto/rivnut.html (6 of 10) [15/05/2003 5:56:43 PM]