8 - 14
–+
ELEC
IGNITION SYSTEM
EAS00752
YES
NO
EAS00753
YES
NO
EAS00754
YES
NO
11.Sidestand switch
• Check the sidestand switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the sidestand switch OK?
Replace the side-
stand switch.
12.Starting circuit cut-off relay
• Disconnect the starting circuit cut-off relay
from the wire harness.
• Connect the pocket tester (
Ω
×
1) to the
starting circuit cut-off relay terminals as
shown.
• Check the starting circuit cut-off relay for
continuity.
Tester positive probe
→
blue/green
1
Tester negative probe
→
blue/yellow
2
Continu-
ity
Tester positive probe
→
blue/yellow
1
Tester negative probe
→
blue/green
2
No conti-
nuity
Lg
L/G
L/Y
Sb
B/Y
B
R/B
L/W
NOTE:
@
When you switch the positive and negative
tester probes, the readings in the above chart
will be reversed.
@
• Are the tester readings correct?
Replace the starting
circuit cut-off relay.
13.Wiring
• Check the entire ignition system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
• Is the ignition system’s wiring properly con-
nected and without defects?
Replace the ECU. Properly connect or
repair the ignition
system’s wiring.
