Filter
Top Products
69
Creating a Rhythm Set
Creating a Rhythm Set
RHYTHM MFX (Rhythm Multi-Effects)
RHYTHM CHORUS
RHYTHM REVERB
Adjusting Effect Settings
Refer to Patch/Rhythm Set Mode Settings (p. 77).
Saving Rhythm Sets You Create
Refer to Saving a Sound You Create (p. 92).
ENV MODE
(Rhythm tone envelope mode)
NO-SUS, SUSTAIN When a loop-type waveform is selected, it will normally continue to sound as
long as a key is pressed. If you want a note to decay naturally even when the
key remains pressed, set this to “NO-SUSTAIN.”
* If a one-shot type Wave is selected, it will not sustain even if this parameter is set
to “SUSTAIN.”
RCV EXP
(Rhythm tone receive expression
switch)
OFF, ON If you want the Rhythm Tone to respond to Expression messages, turn this pa-
rameter on. If not, turn it off.
RCV HOLD-1
(Rhythm tone receive hold 1
switch)
OFF, ON If you want the Tone to respond to Hold 1 messages, turn this parameter on.
If not, turn it off.
RCV PAN MODE
(Rhythm tone receive pan mode)
CONTINUOUS,
KEY-ON
CONTINUOUS: Pan messages will be responded to immediately, instantly
changing the stereo position of the Rhythm Tone. KEY-ON: The stereo loca-
tion of the Rhythm Tone will be changed only when the next note is played. If
a Pan message is received while a note is sounding, its stereo location will not
change.
Parameter Description
TYPE
(Multi-Effects Type)
Refer to p. 80.
SEND LEVEL DRY
(Multi-Effects Dry Send Level)
SEND LEVEL CHO
(Multi-Effects Chorus Send Level)
SEND LEVEL REV
(Multi-Effects Reverb Send Level)
CONTROL SOURCE 1–4
(Multi-Effects Control Source 1–4)
DESTINATION 1–4
(Multi-Effects Control Destination 1–4)
SENS 1–4
(Multi-Effects Control Sensitivity 1–4)
Parameter Description
TYPE
(Chorus Type)
Refer to p. 80.
LEVEL
(Chorus Level)
OUTPUT SELECT
(Chorus Output Select)
Parameter Description
TYPE
(Reverb Type)
Refer to p. 80.
LEVEL
(Reverb Level)
Parameter Value Description