Kenwood XV-2020 Recording Equipment User Manual


 
82
Using the XV-2020 Effects
Multi-Effects Parameters
The multi-effects feature 90 different kinds of effects. Some of the
effects consist of two or more different effects connected in series or
in parallel.
Parameters marked with a sharp “#” can be simultaneously
controlled using the selected controller.
1: STEREO EQ (p. 82)
2: OVERDRIVE (p. 82)
3: DISTORTION (p. 82)
4: PHASER (p. 83)
5: SPECTRUM (p. 83)
6: ENHANCER (p. 83)
7: AUTO WAH (p. 83)
8: ROTARY (p. 83)
9: COMPRESSOR (p. 84)
10: LIMITER (p. 84)
11: HEXA-CHORUS (p. 84)
12: TREMOLO CHORUS (p. 84)
13: SPACE-D (p. 85)
14: STEREO CHORUS (p. 85)
15: STEREO FLANGER (p. 85)
16: STEP FLANGER (p. 85)
17: STEREO DELAY (p. 86)
18: MODULATION DELAY (p. 86)
19: TRIPLE TAP DELAY (p. 87)
20: QUADRUPLE TAP DELAY (p. 87)
21: TIME CONTROL DELAY (p. 87)
22: 2 VOICE PITCH SHIFTER (p. 87)
23: FB PITCH SHIFTER (p. 88)
24: REVERB (p. 88)
25: GATED REVERB (p. 88)
26: OVERDRIVE -> CHORUS (p. 88)
27: OVERDRIVE -> FLANGER (p. 89)
28: OVERDRIVE -> DELAY (p. 89)
29: DISTORTION -> CHORUS (p. 89)
30: DISTORTION -> FLANGER (p. 89)
31: DISTORTION -> DELAY (p. 89)
32: ENHANCER -> CHORUS (p. 89)
33: ENHANCER -> FLANGER (p. 90)
34: ENHANCER -> DELAY (p. 90)
35: CHORUS -> DELAY (p. 90)
36: FLANGER -> DELAY (p. 90)
37: CHORUS -> FLANGER (p. 91)
38: CHORUS/DELAY (p. 91)
39: FLANGER/DELAY (p. 91)
40: CHORUS/FLANGER (p. 91)
1: STEREO EQ (Stereo Equalizer)
This is a four-band stereo equalizer (low, mid x 2, high).
fig.02-001m
2: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum tube
amplifiers.
fig.02-002m
3: DISTORTION
Produces a more intense distortion than Overdrive. The parameters
are the same as for “2: OVERDRIVE.”
fig.02-003m
Parameter Value Description
Low Freq 200, 400 Hz Frequency of the low range
Low Gain -15-+15 dB Gain of the low frequency range
Mid1 Freq 200-8000 Hz Frequency of Middle Range 1
Mid1 Gain -15-+15 dB Gain of Middle Range 1
Mid1 Q 0.5, 1.0, 2.0, 4.0,
8.0
Width of Middle Range 1
Select a higher Q value to narrow
Middle Range 1.
Mid2 Freq 200-8000 Hz Frequency of Middle Range 2
Mid2 Gain -15-+15 dB Gain of Middle Range 2
Mid2 Q 0.5, 1.0, 2.0, 4.0,
8.0
Width of Middle Range 2
Select a higher Q value to narrow
Middle Range 2.
High Freq 2000, 4000, 8000
Hz
Frequency of the high range
High Gain -15-+15 dB Gain of the high frequency range
Level # 0-127 Output level
Parameter Value Description
Drive # 0-127 Amount of distortion
Also changes the volume.
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double-stack amp
3-STACK: large triple-stack amp
Low Gain -15-+15 dB Gain of the low frequency range
High Gain -15-+15 dB Gain of the high frequency range
Level 0-127 Output level
Pan # L64-63R Stereo location of the OVERDRIVE
output
L in
R in
L out
R out
4-Band EQ
4-Band EQ
Amp
Simulator
2-Band
EQ
L in
R in
Over
drive
L out
R out
Pan R
Pan L
L in
R in
L out
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion