Filter
Top Products
Use the PATCH/BANK [
2.
▼]/[▲] foot
switches to select a patch.
For example, pressing the PATCH/BANK [▲]
foot switch repeatedly will cycle through the
groups, banks, and patches as shown in the
above illustration.
HINT
• The [BANK/PATCH] indicator shows only the
bank number and patch number. To identify
the current group name, check the display.
• You can also switch the group/bank/patch by
turning the [TYPE] knob.
Turning a module on
and off
In manual mode, you can use foot switches 1 – 4
to switch specifi c modules on and off. The main
modules of the currently selected patch can be
controlled in this way.
Each foot switch is marked with the names of
two modules. One of these modules is controlled
by the switch. The top and bottom LEDs of
the foot switch indicate which module is being
controlled and its current status, as follows. LED
lit: module on. LED fl ashing: module off.
The illustration below shows the foot switches
and respective modules.
HINT
• You can change the modules assigned to the
foot switches 1 – 4 (→ p. 38).
• The module on/off settings are not
automatically retained when you change to
another patch. If necessary, store the patch to
retain the new settings (
→ p. 27).
15
ZOOM B9.1ut
Switching Modules On and Off (Manual Mode)
PATCH/BANK [▲] foot switch
< < < < <
User group (U)
Preset group (P)
<1 <1
7 7
7
7 7 71 71
Foot switch 1 Foot switch 2 Foot switch 3 Foot switch 4
WAH/EFX1 module
EXT LOOP module
LED for controlled module is on or flashing
EQ module
REVERB module
COMP module
PRE-AMP module
MOD-EFX2 module
DELAY module