Zoom B9.1ut Musical Instrument Amplifier User Manual


  Open as PDF
of 88
 
69
ZOOM B9.1ut
Effect Types and Parameters
DigiFuzz
High gain fuzz sound with strong character.
The above 21 effect types have the same parameters.
GAIN LEVEL
Gain
0 – 100
Level
1 – 100
Adjusts the preamp gain (distortion depth).
Adjusts the signal level after passing the
module.
PARM1 PARM2 PARM3
Tone
0 – 30
MixBal
0 – 100
Chain
Pre, Post
Adjusts the tonal quality of the sound.
Adjusts the balance between original sound and
effect sound.
Selects the connection position of the pre-amp
section. Available settings are "Pre" (before
MOD/EFX2 module) or "Post" (after DELAY
module).
StdSyn (Standard Synthesizer)
ZOOM original bass synthesizer sound.
GAIN LEVEL
Sense
0 – 100
Level
1 – 100
Adjusts the sensitivity for trigger detection.
Adjusts the signal level after passing the
module.
PARM1 PARM2 PARM3
Variation
1 – 4
Tone
0 – 10
MixBal
0 – 100
Selects a synthesizer variation. Adjusts the tonal quality of the sound.
Adjusts the balance between original sound and
effect sound.
SynTlk (Synthesizer Talk)
This effect produces a synthesizer sound similar to a talking modulator producing vowels.
GAIN LEVEL
Decay
0 – 100
Level
1 – 100
Adjusts the rate of sound change.
Adjusts the signal level after passing the
module.
PARM1 PARM2 PARM3
Variation
iA, UE, UA,
oA
Tone
0 – 10
MixBal
0 – 100
Selects a vowel variation. Adjusts the tonal quality of the sound.
Adjusts the balance between original sound and
effect sound.
V-Syn (Vintage Synthesizer)
This effect produces a vintage bass synthesizer sound.
GAIN LEVEL
Decay
0 – 100
Level
1 – 100
Adjusts the rate of sound change.
Adjusts the signal level after passing the
module.
PARM1 PARM2 PARM3
Sense
0 – 30
Range
-10 – 10
MixBal
0 – 100
Adjusts the sensitivity for trigger detection. Adjusts the fi lter shift range.
Adjusts the balance between original sound and
effect sound.
MonoSyn (Mono Synthesizer)
This effect produces the sound of a monophonic (single-note playing) bass synthesizer that detects the pitch of the input signal.
GAIN LEVEL
Decay
0 – 100
Level
1 – 100
Adjusts the rate of sound change.
Adjusts the signal level after passing the
module.
PARM1 PARM2 PARM3
Variation
Saw, Pulse,
PWM
Resonance
0 – 10
MixBal
0 – 100
Sets the waveform type to "Saw" (sawtooth),
"Pulse" (square wave), or PWM (pulse width
modulation resulting in fatter sound).
Adjusts the intensity of the effect character.
Adjusts the balance between original sound and
effect sound.
 previous next