Filter
Top Products
41
ZOOM B9.1ut
Using the Effect Loop
,?;3667
w9L[3L]LS$l
Parameter knob 2
Use parameter knob 3 to adjust
6.
the level balance between the
signal returned from the external
effect and the internal signal of the
B9.1ut (dry level).
,?;3667
p+Y`3L]LS$l
Parameter knob 3
HINT
• If the external effect is the type that mixes
effect sound to the original sound (such as
a reverb, delay, or chorus), adjust the level
balance between original sound and effect
sound by adjusting the return level and dry
level.
• If the external effect is the type that
processes the input signal for output (such
as a compressor or EQ unit), the dry level
should normally be set to 0 and the signal
level should be adjusted with the return level
parameter.
When the effect loop settings have
7.
been made, press the [EXIT] key.
The unit returns to manual mode or play mode.
Store the patch as necessary.
8.
When you next call up the stored patch, the
external effect settings will also become
effective again.
HINT
If the external effect supports MIDI based
program switching, the B9.1ut can control the
effect by sending program change messages.
In this way, patch switching at the B9.1ut
and program switching at the B9.1ut can be
synchronized (→ p. 43).