Filter
Top Products
44
ZOOM B9.1ut
MIDI Usage Examples
To enable the B9.1ut to receive
2.
program change (+ bank select)
messages, turn the [TYPE] knob to
bring up the "MIDI PC Rx" (receive
program change) parameter, and
turn parameter knob 1 to select
the "ON" setting.
40+0
7*9_$65l
Parameter knob 1
To enable the B9.1ut to send
3.
program change (+ bank select)
messages, turn the [TYPE] knob
to bring up the "MIDI PC Tx" (send
program change) parameter, and
turn parameter knob 1 to select
the "ON" setting.
40+0
7*;_$65l
Parameter knob 1
When the setting is complete,
4.
press the [EXIT] key to cancel the
SYSTEM menu.
If a setting was changed, the indication
"Store...?" appears on the display, to allow you
to store the changes.
:[VYL&
@B:;69,D5B,?0;D
If no setting was changed, the unit returns to the
previous mode.
Press the [STORE/SWAP] key to
5.
save the changes.
The setting is accepted, and the unit returns to
manual mode or play mode.
By pressing the [EXIT] key, you can abort the
changes and return to play mode without saving.
■ Using direct mode
By using a combination of MIDI bank select
and program change messages, you can specify
a patch directly.
NOTE
Before carrying out the following steps, verify
that the send/receive MIDI channel setting of
the B9.1ut is as required (→ p. 42), and that
send/receive of program change messages is
enabled (→ p. 43).
In play mode, press the [SYSTEM]
1.
key.
70*2<7:LS
(*;0=,
Turn the [TYPE] knob to bring up
2.
the "MIDI PCMODE" (program
change mode) parameter.
40+07*46+,
+09,*;
[TYPE] knob
Verify that "DIRECT" is selected as
3.
program change mode.
If not, turn parameter knob 1 to change the
indication to "DIRECT". This enables direct
selection of all patches using bank select and
program change messages.
HINT
For information on which bank number/program
change number is assigned to each patch, see
the list at the end of this manual (→ p. 83).
When the setting is complete,
4.
press the [EXIT] key to cancel the
SYSTEM menu.
If a setting was changed, the indication
"Store...?" appears on the display, to allow you
to store the changes. If no setting was changed,
the unit returns to the previous mode.