Filter
Top Products
The right digit of the [BANK/PATCH] indicator
shows how the pitch differs from the displayed
note.
Pitch is high Pitch is correct
Indication turns faster the more the pitch is off
Pitch is low
The "><" under the display also shows by how
much the pitch differs.
%¼#
*/964(;*/a
%¼
%¼
%¼
%¼
%¼#
¼#
¼#
¼#
¼#
Pitch is high
Pitch is correct
Pitch is low
Tune the string of your instrument
3.
while checking the note and pitch
indication.
HINT
First you should perform rough tuning to bring
up the desired note indication. Then fi ne tune
the pitch while watching the right digit of the
[BANK/PATCH] indicator and the lower part of
the display.
To change the reference pitch of
4.
the tuner, turn parameter knob 1.
*/964(;*/a
¼
Parameter knob 1
After the B9.1ut is turned on, the tuner reference
pitch is always "440 Hz (center A = 440 Hz).
The adjustment range using parameter knob 1 is
center A = 435 – 445 Hz, in 1-Hz steps.
HINT
When the B9.1ut is turned off and on again, the
reference pitch will be reset to 440 Hz. You can
change the default frequency that will be used
after a reset (→ p. 59).
When tuning is completed, press
5.
the [BYPASS/TUNER] key.
The B9.1ut returns to manual mode or play
mode.
Using the bass tuner
Besides chromatic tuning, the B9.1ut also offers
standard tuning for bass. To use this function,
proceed as follows.
Switch the B9.1ut to the bypass or
1.
mute mode as described in step 1
of "Using the chromatic tuner".
The display shows the tuning indication.
Turn the [TYPE] knob to select
2.
"BASS" as tuner type.
The [BANK/PATCH] indicator display changes
as follows.
21
ZOOM B9.1ut
Using the Tuner (Bypass/Mute Mode)