Filter
Top Products
32
ZOOM B9.1ut
Using the Expression Pedal
HINT
• The available range setting depends on the
parameter selected in step 4.
• It is also possible to set "min" to a higher
value than "MAX". In that case, the parameter
value will be minimum when the pedal is fully
depressed and maximum when the pedal is
fully raised.
To use the expression pedal for
6.
switching the module on and off,
turn parameter knob 4 and select
"Switch:Enable".
When you turn parameter knob 4, the display
changes as follows.
7=$4P_l
o:^P[JO!,UHISL
Parameter knob 4
The expression pedal has a switch that is
triggered when the pedal is pushed a bit further
in the vertical direction, after the fully down
position is reached. The module to which the
selected parameter belongs will be switched on
or off.
If you select "Disable" by turning parameter
knob 4, module on/off switching will not be
available.
HINT
• When "Volume" is the control target and
"Enable" is selected, the volume pedal
function can be switched on and off. The effect
of on/off switching can be verifi ed by checking
the status of the [VOLUME PEDAL] LED to
the left of the expression pedal.
• It is also possible to use the pedal normally
for volume control and to switch a module
on and off by pushing the pedal fully down.
To achieve this, set the volume pedal on/off
status, and the control target module on/off
status to the opposite condition (
→ p. 33).
Repeat steps 3 – 6 to set the other
7.
control targets for the vertical
direction in the same way.
To assign control targets for the
8.
horizontal direction, turn the
[TYPE] knob to select one of the
four horizontal direction control
targets (PH1 to PH4).
The display changes as follows.
7/$4P_
46+!*OVY\Z
Control target
indication
Control target
parameter name
Module name
Effect type name
[TYPE] knob
The operation steps for setting the horizontal
direction control targets PH1 to PH4 are the
same.
Repeat steps 4 – 5 to set the
9.
parameter and minimum and
maximum values for the control
target.
NOTE
In the horizontal direction of the expression
pedal, no module on/off switching is possible.
Repeat steps 8 – 9 to set the other
10.
control targets for the horizontal
direction in the same way.
NOTE
It is also possible to specify the same parameter
for more than one control target, but in some
cases, extreme parameter value changes may
lead to noise. This is not a defect.
When all settings for expression
11.
pedal have been made, press the
[EXIT] key.
The unit returns to manual mode or play mode.
NOTE
Pedal settings will be lost when you select a new
patch. Be sure to store the patch if you want to
keep the changes (→ p. 27).