Filter
Top Products
59
ZOOM B9.1ut
Other Functions
all patches appears.
70*2<7:LS
(*;0=,
Turn the [TYPE] knob to bring
2.
up the indication for the "USB
Monitor" parameter (output mode
when USB connection is used).
<:)4VUP[VY
<:)+09,*;
[TYPE] knob
Turn parameter knob 1 to select
3.
one of the following settings.
● USB+DIRECT
The signal after effect processing appears
directly at the OUTPUT jacks also when USB
connection is used.
● USB Only
The signal after effect processing is muted,
and only the signal sent from the computer
via the USB connection is output.
When the setting is complete,
4.
press the [EXIT] key.
HINT
The USB Monitor setting is returned to the
default (USB+DIRECT) at the next power-
down/power-up cycle.
Changing the default
reference pitch of the
tuner
You can specify the reference pitch of the built-
in tuner that will be established at power-on.
In manual mode or play mode,
1.
press the [SYSTEM] key.
The SYSTEM menu for parameters that apply to
all patches appears.
Turn the [TYPE] knob to bring up
2.
the indication shown below.
;\ULY*HSPI
/a
[TYPE] knob
Turn parameter knob 1 to change
3.
the reference pitch.
When the setting is complete,
4.
press the [EXIT] key.
If the setting was changed, the indication
"Store...?" appears on the display, to allow you
to store the changes.
If the setting was not changed, the unit returns
to the previous mode.
Press the [STORE/SWAP] key to
5.
store the new setting.
If you press the [EXIT] key, the change will be
discarded and the unit returns to the previous
mode.
Use as a direct box
The BALANCED OUT connectors on the rear
panel let you use the B9.1ut as a direct box for
sending the bass signal directly to a PA mixer
or recording console. (Gain: 0 dB, output
impedance: 200 ohms, HOT-COLD)
To use this function, connect the BALANCED
OUT connectors of the B9.1ut to the PA mixer or
recording console, using XLR balanced cables.
If the signal causes distortion in the input stage
of the other equipment, set the OUTPUT GAIN
switch of the B9.1ut to "-10 dB". At the same
time, you can also connect the OUTPUT jack to
a bass amplifi er for monitoring.