Filter
Top Products
46
ZOOM B9.1ut
MIDI Usage Examples
7*4(77YN!
w)UR!<p7H[!
Program change number
Group name/bank number
Patch number
[TYPE] knob
To assign a patch to a program
5.
change number, proceed as
follows.
(1) Turn parameter knob 1 until the
program change number to use is
shown on the top line of the display.
7*4(77YN!
w)UR!<p7H[!
Program change number
Group name/bank number
Patch number
Parameter knob 1
(2) Use parameter knobs 2 and 3 to
select the group name/bank number
and patch number to assign to the
program change number selected in
step (1).
7*4(77YN!
w)UR!< lp7H[!l
Parameter knob 2
Parameter knob 3
(3) Repeat these steps for other program
change numbers.
When the setting is complete,
6.
press the [EXIT] key to cancel the
SYSTEM menu.
If a setting was changed, the indication
"Store...?" appears on the display, to allow you
to store the changes.
If no setting was changed, the unit returns to the
previous mode.
Press the [STORE/SWAP] key to
7.
save the changes.
The setting is accepted, and the unit returns to
manual mode or play mode.
By pressing the [EXIT] key, you can abort the
changes and return to play mode without saving.
To send and receive program
8.
change messages, proceed as
described in step 6 of "Using
direct mode" (→ p. 44).
The program change (+ bank select) messages
sent by the unit are the same in direct mode and
mapping mode. For information on which bank
number/program change number is assigned to
each patch, see the list at the end of this manual
(
→ p. 83).
Sending and receiving
pedal/switch/key operation
information via MIDI
(control change)
The B9.1ut allows sending and receiving control
change messages via MIDI. These messages
govern actions such as operating the expression
pedal, and switching modules or bypass/mute on
and off with keys and foot switches. Each action
can be assigned its own control change number
(cc#).
■ Enable control change send/receive
The procedure for enabling send/receive of
control change messages is described below.
In manual mode or play mode,
1.
press the [SYSTEM] key.
70*2<7:LS
(*;0=,