Filter
Top Products
Edition 3
Rev G
Section 4
4-15
C
O
S
T
A
N
T
S
&
C
U
S
T
O
M
C
U
R
V
E
S
2. Press the to advance to the next parameter, VALUE.
3. Press the and the display advances to the next constant to be programmed. Refer to the beginning of
this section, page 4-14.
4.1.3 CUSTOM CURVES
Custom Curves are available only when MATH has been specified and present in the model number order matrix.
Custom Curves allow the user to define up to 21 point "custom curve".
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Con-
figuration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to
Section 9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until CUSTOM CURVES appears in the
lower display line.
(Continued on next page)
Press the to change, then to
desired position, then to desired number,
then press the . This will change the value (left number). Then change the exponent (right number) and
then press .
CVx VALUE
1.00000 E 0
Selections
-9.99999E37 to 9.99999E37