Filter
Top Products
Section 4Edition 3
Rev G
4-66
Press the to change, then to
desired choice, then press the .
7. Press the to advance to the next parameter, DISPLAY OPTION.
8. Press the and the display advances to the next timer to be programmed. Refer to the beginning of this
section, page 4-61.
4.1.9 LEDS
In this section, each of the available 8 individual LEDs can be configured to operate on any of the available
actuators.
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuraiton has been disabled. Refer to Section 9,
Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until LEDS appears in the lower display
line.
1. Press the to display LED NUMBER.
TMx DISPLAY OPTION
IN BOTH MODES
Selections
NOT DISPLAYED
IN CONTINUOUS MODE
IN SEQUENTIAL MODE
IN BOTH MODES
T
I
M
E
R
S
&
L
E
D
S
Press the to change, then to
desired choice, then press the .
LED NUMBER
1
Selections
1 to 8