Filter
Top Products
Edition 3
Rev G
Section 4
4-89
4.1.15 OPERATOR MESSAGES
Operator Messages are user defined messages to advise or provide information, via the display, that selected
actuators are active.
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to
Configurat allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until OPERATOR MESSAGES appears
in the lower display line.
1. Press the to display OPERATOR MESSAGE.
2. Press the to advance to the next parameter, COPY/INITIALIZE.
Choose YES if the parameters to be programmed are the same as another OPERATOR MESSAGE already
programmed.
OPERATOR MESSAGE
1
Selections
1 to 12
Press the to change, then to
desired number, then press the .
Press the to change, then to
desired choice, then press the .
OMxx COPY / INITIALIZE
NO
Selections
NO YES
O
P
E
R
A
T
O
R
M
E
S
S
A
G
E
S