Filter
Top Products
Section 4Edition 3
Rev G
4-14
28. Press the to advance to the next parameter, DISPLAY FILTER.
29. Press the and the display advances to the next input to be programmed. Refer to the beginning of this
section, page 4-1.
4.1.2 CONSTANTS
Constants are available only when MATH has been specified and present in the model number order matrix.
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until CONSTANTS appears in the lower
display line.
1. Press the to display CONSTANT NUMBER.
Press the to change, then or
, then to desired value,
then press the .
Press the to change, then to
desired number, then press the .
CONSTANT NUMBER
1
Selections
1 to 12
IVx DISPLAY FILTER
0 SECONDS
Selections
0 to 9999 seconds
I
N
P
U
T
S
&
C
O
S
T
A
N
T
S