Filter
Top Products
Edition 3
Rev G
Section 4
4-85
4. Press the and the display advances to the next derived actuator to be programmed. Refer to the
beginning of this section, page 4-80.
4.1.14 OPERATOR INPUTS
Operator Inputs are prompts programmed that allow these prompts to turn on or off actuators that control some
other function within the instrument.
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9,
Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until OPERATOR INPUTS appears in the
lower display line.
1. Press the to display OPERATOR INPUT.
2. Press the to advance to the next parameter, COPY/INITIALIZE.
D
E
R
I
V
E
D
A
C
T
U
A
T
O
R
S
&
O
P
E
R
A
T
O
R
I
N
P
U
T
S
OPERATOR INPUT
1
Selections
1 to 12
Press the to change, then to
desired number, then press the .
Press the to change, then to
desired choice, then press the .
OIxx COPY / INITIALIZE
NO
Selections
NO YES