Filter
Top Products
Section 4Edition 3
Rev G
4-70
Press the to change, then ,
, as required to desired choice, then
press the .
4. Press the to advance to the next parameter, RELAY T.P. VALUE (only seen if RELAY USAGE selected
was TIME PROPORTIONING).
5. Press the to advance to the next parameter, CYCLE TIME (only seen if RELAY USAGE selected is
TIME PROPORTIONING).
6. Press the and the display advances to the next relay to be programmed. Refer to the beginning of this
section, page 4-66.
RELAY x CYCLE TIME
1 SECONDS
Selections
1 to 240
Press the to change, then to
desired value, then press the .
R
E
L
A
Y
S
RELAY x T.P. VALUE
NONE USED
Selections
NONE USED
IV1 IV2 IV3 IV4
IV5 IV6 IV7 IV8
PV1 PV2 PV3 PV4
DV1 DV2 DV3
DV4 DV5 DV6
DV7 DV8 DV9
DV10 DV11 DV12
CV1 CV2 CV3 CV4
CV5 CV6 CV7 CV8
CV9 CV10 CV11 CV12
TOTAL1 TOTAL2
TOTAL3 TOTAL4
SV1 SV2 SV3 SV4
Additional selections for use with controller option:
SP1 SP2 SP3 SP4
SP5 SP6 SP7 SP8
OUTPUT 11 OUTPUT12
OUTPUT 21 OUTPUT22
OUTPUT 31 OUTPUT32
OUTPUT 41 OUTPUT42