Filter
Top Products
Edition 3
Rev G
Section 13
13-35
8. Press the to advance to the next parameter, INTEGRATION BAND (only if proportional output).
Cx INTEGRATION BAND
100 units
Note: Units correspond to Units
configured in Process Variables.
Selections
0 to 999999
(decimal position=0)
0 to 9.9999
(decimal position=4)
INTEGRATION BAND sets the range where integration of the error will occur, centered on the control setpoint.
9. Press the to advance to the next parameter, INTEGRATION SHIFT (only if proportional output).
Cx INTEGRATION SHIFT
0 units
Note: Units correspond to Units
configured in Process Variables.
Selections
0 to 999999
(decimal position=0)
0 to 9.9999
(decimal position=4)
INTEGRATION SHIFT represents a shift or offset for the integration band from its normal operating position,
centered on the control setpoint.
Press the to change, then or
to desired number, then press the .
Press the to change, then or
to desired number, then press the .